[gme-users] how to adjust the size of a model ?

[Zoltan Molnar]

Hi,
 
Currently there is no way of adjusting model sizes to the name's length. The only adjustment possible is the 'Port Label Length' on the Preference panel of any model, which value indicates how much of a port label is shown. Default is 3. If 0 is set then the whole port name is shown, that is why the model box is enlarged horizontally until the port labels fit into this width.
 
Zoli
 
-----Original Message-----
From: gme-users-bounces at list.isis.vanderbilt.edu [mailto:gme-users-bounces at list.isis.vanderbilt.edu] On Behalf Of Song Zhu-mei
Sent: Thursday, March 23, 2006 6:11 AM
To: gme-users
Subject: [gme-users] how to adjust the size of a model ?



Hi Zoli,

Thanks a lot for your help on the last problem. But I came across a new problem. When a long name is displayed in the center of a model, it is out-of-boundary. Can model size changes according to its name length? Or, how to adjust the size of a model so as to have a better layout when modeling? 

 

Regards,

 

Zhumei

--

Zhumei Song

Ph.D Candidate

College of Mechanical Engineering, South China University of Technology, Guangzhou, China.

Phone: +86-20-87114637

Email: melody78 at 126.com

 
 
 








Äã Öª µÀ 2006 Äê ×î »ð ±¬ µÄ µç ×Ó ÓÊ Ïä Â𠣿 
¶à ´ï 1.1 ÒÚ ÖÐ ¹ú ÈË Ñ¡ Ôñ Íø  <http://www.126.com/help/126fab.htm> Ò× 2000 Õ× Ãâ ·Ñ ÓÊ Ïä £¬ ÇÀ ×¢ ÔÙ µÃ 280 Õ× ³¬ ´ó Íø ÅÌ 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://list.isis.vanderbilt.edu/pipermail/gme-users/attachments/20060323/27480021/attachment.htm